The first step to setting up motion recording is to make sure the software is setup for it.

  1. To enter the Record Schedule Setting, click on System Settings ().

    xlplus_camera_config1

    IP Camera Settings For Motion Detection

  2. Click on Record Schedule Setting on the left. Here we can select when we would like the cameras to record on motion or a schedule.

  3. Select the camera from the drop down menu.

  4. By default the system is setup to do Motion Rec. (MotionRec) in Purple. To change this select either Normal Rec. (NormalRec) in Green or Normal&Motion Rec. (NormalMotionRec) in Blue

  5. Click, hold, and drag the cursor over the time frame you would like to set.

  6. Normal Recording does recording full time.

  7. Normal&Motion Recording is full time recording but displays where there is motion on the playback time line.

Below is an example of a camera recording on motion from 8:00 am-5:00pm then recording Normal&Motion from 5:00 pm-8:00 am.

Motion_Schedule

Motion Schedule

After the record schedule is set or if you just wish to leave everything on motion we can enter the camera’s settings to setup it’s motion properties.

  1. Click on Exit the System Setting Screen.

  2. Click on the Channel Setting (ipcUp) button.

    xlplus_channel_settings

    Camera Channel Screen/Setting Motion Range

  3. Click on Motion Detection on the left menu.

  4. At the top of the screen, select the device (camera) you want to enable motion.

  5. Enable should be checked, if not, click on Enable.

  6. Once it is enabled, there will be yellow outline around the video. This will flash red when motion is detected.

  7. If the entire area is to be included in the motion video, the flashing box should include the entire square of the video.

  8. The motion area can be modified. To set this area, click on the Clear All button.

  9. In the video square, left click, hold, and drag the mouse to select the area desired. If a mistake is made, click on Clear All and start over.

  10. To adjust the Sensitivity use the scroll bar next to the video square. After the sensitivity settings are adjusted, click on Apply&Save.

  11. To change the settings on additional cameras, repeat steps 4-11.

  12. Click on Exit to return to the main screen.

The cameras are now setup for motion recording. In the main screen under the device list you should see a running man icon (motion) when motion is detected and a clock icon (schedule) when it is recording on schedule. If there is no icon next to the camera name, it is not recording.